Cookie Cutter Generator › Christmas cookie cutters › Christmas Wreath
About this christmas wreath cookie cutter
A scalloped wreath with a centre hole – the template cuts both the outside and the inside in one press. The template opens at 90 mm, a good size for this shape, but you can make it anywhere from 30 to 200 mm.
- Recommended size: 90 mm on the longest side
- Blade: 1.0 mm thick, 15 mm tall (increase to 1.2 mm above 120 mm)
- Print time: roughly 25–40 minutes in PLA, no supports
Decorating idea
Pipe small green leaves all around with a leaf tip, then add a red bow at the bottom.
Food safety: wash printed cutters by hand in warm soapy water, use them for short contact with chilled dough, and consider food-safe filament.